This is going to be a large church/temple type building for use in D&D. So far the bottom piece has been completed and I am working on the roof and bell tower.
I print with abs at 232 tip and 100 hot bed. Note if your printer is not enclosed there is a chance that some of the corners will warp and not adhere between some layers. This is due to the model being so large that by the time the printer makes it from one corner to the next the layer before may have cooled too much for the old layer and new layer to adhere to each other. So I recommend either splitting the model in half or finding a way to enclose your printer so the heat gets trapped a bit better.