It's a bird, It's a plane, No! It's...well...um both?!
An ornithoter is a flying machine that acquires lift by flapping a pair of wings. It converts rotational energy into linear (flapping) movement with a crankshaft at the front. Way back when, smart people, like da Vinci, believed this was the easiest way to give man powered flight. We know that this assumption was clearly wrong. Experiment launching this device at different angles ,relative to the wind, to get the best flight possible. (The wind may also assist in some crazy acrobatics!) All you need to do now is print/assemble your Ornithopter and get ready to take to the skies! https://youtu.be/W-_lnUAN0RA
-1/32" dia wire(I used welding wire)
-super glue or epoxy
-needle nosed pliers
(for bamboo skewers)
-two 7" wing spars
-two 5" tail pieces
-one 6" fuselage
-one 2 3/4" crankshaft
-two 5/8" hinge pins
it's pretty standard... I just printed with default settings on slicer, no support needed. The tail file needs to be flipped 180* so it looks like an n
1- put a piece of wire in the drill and drill out all of the small holes. (the piece should spin freely on the wire afterwards)
2-bend the crankshaft as shown on the pictures above and insert into the bottom hole of the front piece. once inserted bend the back of the crankshaft up to create a hook
3-reffering to the picture of the front (the one with the purple F for front and yellow H for hinges) cut along the red line. Next, attach tape to this segment to create a flexible hinge. (I had to redesign this many times in order to get a low friction hinge mechanism)
4-insert hinge pins into hinge holes and attach the connecting rods to the crankshaft and hinge pins (see featured pic for accurate placement) Then bend hinge pins up to keep connecting rods in place.
5-super glue spars into hinges and body into front piece (see featured pic)
6-hot glue tail and tail clip together then superglue bamboo tail pieces onto tail. Next, glue entire tail assembly onto fuselage
7-flip ornithopter over and trace a wing design onto the spars and tail. cut wing and tail skin out of tissue paper
8- using wood glue, glue wing skin onto spars and the center of the wing onto the fuselage. ENSURE THE WINGS ARE IN THE DOWN POSITION WHEN GLUEING.
9- glue on tail skin
10- glue an elastic band to the rear of the fuselage and hook it onto the crankshaft hook
11- lubricate elastic band (prevents wear) and wind er up!
12- release at 20* and hopefully she flies.