When I was building ToyREP 3D Printer, burned one stepper, so I took it apart. Maybe you will find it useful for some future project.
When it was disassembled I made also model of the plastic cap as it get broken very easily. You can use it as a replacement or to customize the colour but beware it was not tested yet.
This particular motor have gears:
9 teeth on motor shaft
32 to 11 on first axis
22 to 9 on second axis
27 to 8 on third axis
24 teeth on output shaft.
The other motor I got previously had:
- Choose if you want cap with open hole for wires or closed. Open hole will let you install the cap with connector. For closed hole you will have to cut off connector.
- Print it as fine as possible :D.
- Slide wires through the hole
- Put the cap on place.