Light It Up any way you want to! This unique little lamp is fully customizable. All the side panels and top piece are interchangeable and replaceable. The Cowboy Bebop theme is just the start, with blank templates you could give this a look fully customized for you! More themes to come!
This is a project that I had wanted to make for a while now. Once i saw Light it up (albeit a bit late in the game) I knew i had to give it a shot. I'm still relatively new to 3d printing and wiring LEDs, so its had ups and downs throughout the process, but ultimately I'm glad i saw it through.
I started by designing the base panels and top piece. followed by printing them. Adjust as required. The design is pretty straight forward. slide the panels into the slots on the base, then place the top. As for the electronics i used 12 Bright white 3.2v LEDs Wired together in parallel, with 5.6ohm resistors, and a 4.5v power supply. If you know what your doing, you can try something different. The panels and top take about 2-3 hours to print on fast, the base took about a full 24 hours including supports.