Loading

MakerBot Print is our newest print-prepration software, which supports native CAD files and STL assemblies,
allows you to interact with all your printers via the Cloud, and many other exciting new features.

Download Now

keegi

Yet another low-cost leadscrew coupling

by keegi Jun 15, 2011

Please Login to Comment

That is not a lead screw. That is a threaded rod. O.O

Not a bad coupling for threaded rods, but... just... wow.

That is a threaded rod.

Indeed.

I've used this setup on both 3DP's & CNC routers for the past 10 years, never had a failure. I usualy solder or pin the coupler to the threaded rod depending on the size, insert the tubing, then press fit the nema shaft. A little spit helps... ;)
I've use this on nema24's with a 1/2" thread on my drillpress XY table, & it's worked perfectly.
Tip: Use stainless threaded rod & nuts. It's a few extra bucks, but well worth it. Threaded is slower than ACME due to the higher pitch, but it can mean better micro-stepping on a tightly tuned machine, which equals better layers.
Spinning the rod in a drill & knocking the sharp edge off the threads with medium grit sandpaper will make it run much smoother.
Depending on use, I change out the tubing about once a year when I do maintenance.

Hope that helps :)

Al

Hi!
can anyone help me to understand the connection between the flexible tubing and the M8 coupling nut?
Thanks! :D

The threads of the nut should cut into the outer layer of the tubing.

Hahah I love it!!! If only I'd seen this before ordering a set of solid couplers, but oh well.

This is so much smaller than the OEM coupler found in Prusa Mendels. I could gain a couple centimeters of x motion at z=10cm. Very cool. :-)

What type of tubing did you use in your coupler? The two I bought just bind up and tear when I try to thread the nut on.

Damn that's good. I looked at it and it looked a bit flimsy, but trying it its really good.

I attached the coupling and the nut to the rod, used pliers to hold the motor shaft, and screwed the two halves together.

This is great! I printed a few different z couplings, but I could never completely get rid of z axis wobble until I tried your solution.

Thanks for sharing!

I used a lock washer to keep the coupling nut and hex nut together so the the threaded rod didnt accidentally get unscrewed.