Before Printing Please Refer To Instructions
All you need is a standard small DC motor and a couple of wide Popsicle sticks! Put the sticks into the hub and the motor in the body. The rest is up to you!
Apply power to the motor to make a fan.
Read the motor leads with a fan blowing at the turbines blades for a wind power experiment.
I am sorry for the letters in the base. This was originally for an alternative energy sources project.
If you have any questions or requests let me know!
NOTE: The Hub is not the propeller by itself. You MUST insert Popsicle sticks in the sides for it to function
Print the Hub with the largest FLAT face DOWN.
Print the body so that the front face of the motor case is on the same plane as the front edge of the base.
It should look like you are printing an arc