Loading

MakerBot Print is our newest print-prepration software, which supports native CAD files and STL assemblies,
allows you to interact with all your printers via the Cloud, and many other exciting new features.

Download Now

Hey! This thing is still a Work in Progress. Files, instructions, and other stuff might change!
90AWDeclipse

Flask Mod Dual 18650 Vape

by 90AWDeclipse Mar 17, 2015
Download All Files

Thing Apps Enabled

Please Login to Comment

This would be cool if the right files were uploaded..

The top, bottom, and center section are uploaded.

Do you think a sx350J or 350mini would fit in this?

I'm not sure I haven't tried. There is some room in between the bottom tab and the battery stops. So maybe you could fit one. I would advise printing one and wiring it mechanical first. Either way let me know.

I've got an stl file of the chip and I tried sliding it into the flask and it looks like it should fit. What size hole is the fire button you made?

care to share the chip info and stl?

I used a 1/2" switch. If I remember correctly I had to file the hole slightly to make it fit. I don't know what you're plans are for wiring, but I used four dimes and strips of brass to connect them. I was going to use 17mm brass rounds on my second build but never got around to it. The bottom cap had a dime on each side with a spring solder to it. Then I wrapped a piece of brass around the bottom tab which contacted the strip on the bottom cap, which supplied battery negative. Same goes for the battery stops at the top. Its a lot easier to wire an all metal one, because it's just like a mech mod. You're case is your ground. Good luck.

could you fix files --- they don't work well for printing--- netfabb please repost fixed files??

Some people just shouldn't be smoking....Seriously....

can you upload the correct model please?

Um... I think you uploaded the wrong file.

Is there anyway i could get the file for the flask?

you have a 50cal in your files. do you have the files for the flask?