I needed room on my small round table that sits between chairs, as the various remotes, game controllers, and drinks were overwhelming it.
This caddy is designed to mount under the table. It provides two primary remote controls spots with four other spots for less often used remotes. Its massive and will hold some of the largest remotes out there.
The cutouts on the top are to fit around the tables various bits on the underside.
If you find my designs useful, please help by donating.
This was designed to print without support, but a brim will help hold it to the table.
This thing is big. If you need to hold less remotes and build a less massive caddy, just slice off the ends to make it either a four remote caddy or even all the way down to just two.
The mounting holes are only designed for four or six though, but 3M makes some double sided tape with 30lbs holding strength that works very well if you can't use screws.