Size can be scaled
Vulpix_Sit [size: 4cm x 5cm x 4cm Height]
Vulpix_LayDown [size: 4cm x 4cm x 3cm Height]
+Print with Raft.
+Support is not necessary, but keep it on for safe print.
+Default settings for temperature etc.
Inspired by @FLOWALISTIK
// Made for fun, Non-commercial
// This design is based on Pokemon
The model from the picture was printed with a Makerbot Replicator2X. Resolution Low(Faster), 5% - 10% infill, 0.2mm layer height, 90 mm/s extruding speed and 150 mm/s traveling. Default Setting from MakerBot