This is a remix of my 4" bag clip (which was modified from one
created by MasterFX). This one is wider and includes two
It's actually a little over 4" long, but will fit on a 100x100 print bed if
you rotate the z axis 23 degrees and the re-center the part; although
you either need to skip the skirt, or bring it in very close to the print
(around 0.5mm does work on a 100x100 print bed).
I printed in PLA with .2mm layers and 25% infill, no support.
Note that you'll need a well calibrated machine to get the hinge
to print so that it separates and swivels correctly.
Once complete, gently bend the parts back and forth holding it
near the center hinge. You'll feel it click loose and then should