Loading

MakerBot Print is our newest print-prepration software, which supports native CAD files and STL assemblies,
allows you to interact with all your printers via the Cloud, and many other exciting new features.

Download Now

mighty_mace

S&W M&P Shield magazine extension

by mighty_mace Oct 5, 2014
Download All Files

Thing Apps Enabled

Please Login to Comment

The piece snaps into place but isn't shaped quite right. The rear, seen in the image on the bed, doesn't match the angle it should mate to. Unless my scaling mm to inch increase of 2540% was bad, it's a bit off in the width as well. I'll add a funny story/warning, though. I had it on a loaded 8-clip in the car and summer temps were enough with the spring pressure to soften and deform it in PLA form. Came off in the console and I discovered cartridges and part everywhere LOL.

Will this work for the .40 instead of the 9mm?

I'm not sure. I've seen a few for sale listed for both 9mm and 40 so my gut tells me yes, it would fit. Let us know if it does for sure!

It shows up super tiny.

That's a MM to Inches issue. You need to convert