I needed it to mount my new BTT TFT35 V3 to my Creality Ender 3 printer so I made this remix based on the wonderful design by Seraphim202. It re-uses all the stock screws of the original Ender LCD mounting for quick drop-in installation.
Other small changes from the original design include:
- better LCD cutout for the BTT V3 (you will only see the screen, no bezels)
- slightly tighter hold of the 2 piece snap-fit design
- more precise cutouts for reset/speaker/SD card
Hope you like it and big thanks to Seraphim202 for his version that this is based on!
3D Solutech PLA
PLEASE NOTE: SD card printing will not be possible because of stock bed leveling knobs. Bottom right corner level knob needs to be replaced with smaller version for it to work without issues: https://www.thingiverse.com/thing:3703546
To minimize printing without support, I split the cap from the front of the case into its own file (bonus if you wanted to go 2-tone color and print it a different color). Use a little glue to attach it to the front of the case.
Because of the slightly tighter fit, I found I had to sand down 1 peg just a little bit post-print. This ensured it snapping in and staying in tight. If you wanted to reopen it, I found it easiest to pry it open on the USB cutout.