Ever since upgrading to the SKR 1.3 controller board my Mini MKS12864 display would go dim after a while. When BIQU came out with this display with 12864 display emulation I figured it would be the way to go. It's working great so far.
This is a mount intended to fit in the lower electronics box on my CR-10 all-in-one setup. (Thing https://www.thingiverse.com/thing:3336912) The spacing between the mounting tabs is 60mm.
I've included step files so you can adapt it to your needs.
Also included new front panels in case you're using the same setup as me. This controller panel is wider than the Mini MKS12864 one was so the panels need to be resized. Print with zero top or bottom layers and 6 perimeters to achieve the mesh look. I used PrusaSlicer set to 20% honeycomb infill and adjusted the infill angle to 0 degrees.
Prints with no supports in the orientation provided.