In need of a lower angle Session mount? Files will be coming for 10Deg Hero 7 as well as other frames.
I built these for use on CheaterKwads where flying backwards or inverted causes compound angle problems if using too steep of a camera angle for the GoPro Mounts.
printed at 212 degrees. bit of stringing but was able to print on a stock CR10S using most recent CURA with largely default settings.
I originally printed this with 20% infil and the third hole winds up being a bit squishy which it could wind up being a weak point in a crash. Might consider going to 50% infil or 100% infil to increase strength of the mount.