This is my attempt to make case for BigTreeTech TFT24 v1.1 display.
I have designed this case as sturdy as possible without it looking too heavy.
There are accessible SD card slot, USB port, EXT1 & EXT2 ports and serial port. Debug port is NOT accessible after mounting backplate.
Reset button is flush with box, so some tool is needed to push it. It is good idea to clean hole for reset button after printing with drill bit to ensure that it will not stick.
Mount is 18mm wide, so it fits almost any aluminium profile used to build printer frame. You can use it on 2020, 2040, 3030 or any profile with at least 5mm wide slot.
There are 3 variants of main box - for top mount, bottom mount and without mount at all (for easier remixes).
Select any variant, that fits your needs.
You will need to print one Display_YOUR_VARIANT, one Backplate and one Mount.
Edit 2019 10 06 - Uploaded v2 variant of display file. Hole for display is 2mm smaller (cut from right side. This is for cleaner look of display - no metal frame should be visible.
4x M3x15 HEX head screw - main case screws
4x M3x4x5mm brass insert (optional for case screws, they are designed to tap into plastic case - not needed if you don't need extreme stiffness)
2x M3x20 HEX head screw - mount screws (swivel mechanism)
2X M3 nut (nyloc nut prefered) - for mount screws (swivel mechanism)
2x M5 screws and nuts for your printer frame (M5x10 and T-Nuts for aluminium profiles)
Display - print upside down, with display hole on build plate. If your printer does not print bridges well, you can use supports for SD and USB slot, but i have printed it without supports and there was no problem at all.
Backplate - print as is, back surface on buildplate
Mount - print as is