This is a small desktop stand I designed for my Raspberry Pi 3 with touchscreen.
It's designed for 5 Inches touchscreen (similar to this model: https://www.waveshare.com/wiki/5inch_HDMI_LCD).
To assemble, you will need:
- M3x8 screw x4
- M3x12 screw x2
- M3 nut x 2
(I didn't needed nuts for attaching the parts to the screen, but if you prefer using nut anyway, use 6 x M3x12 screws instead).
The stand is very compact so it doesn't take up much space on the desk.
Please feel free to test it and leave any feedback if you feel so.
Thank you :)
Sunlu Carbon Fiber PLA
The stand needs support. It's a bit tricky to remove, but no big deal.
I used overhang angle = 60° with support everywhere.
For the 2 smaller parts, I recommand using a Brim. I may also be easier to rotate them 90° depending of your print settings.