Small Animal Enclosure.
Polish shop here.
Quite simple and modernistic animal enclosure, requres 3 glass panes (one extra optional), some silicone, and a small animal.
Print all parts. Depending if you want windowed hatch or windowless one print a proper version. When needed print with supports from buildplate only.
- Print a Spooderbox vent with no top and bottom layers, dense infill, and 4+ walls. Infill structure will act as a vent holes, make sure they are small enought to not let your animal escape.
Slide into a base and glue using a silicone 2 side glass panels. Slide front panel in but do not apply silicone there, its design to as as a entry point that you can slide in and out at will.
Glue vent to a Spooderbox top using silicone or other glue.
Use silicone to glue Spooderbox top to a base, remember to not glue fron glass panel to anything and make sure you can slide it in/out.
Optionally glue smaller glass pane to a hatch, or use windowless hatch.
- When all silicone sets fill enclosure with decour of your choice, and let your animal in, slide front panel in and close everything using top hatch.
Cubone skull I used as a decour can be found here: https://www.thingiverse.com/thing:2839481
I sized it down to around 5 cm.