Remade from scratch but heavy inspired by lafit https://www.thingiverse.com/thing:3660668
I used his comment section to do improments regarding lens distance from mount.
Made it a bit nicer to look, printed in PLA, would probably look good in wood.
I've tested on Oculus Rift (CV1) and upper head strap goes nicely in between mounts and sensor is not triggered so you can keep HMD plugged in..
Will soon test on Rift S.
Feedback is welcome as this is my first published creation.
I printed without supports with worst filament I have for test prints.
Depending on printer you might have to sand it down a bit at the top or use some supports.
Recomend printing it wall side of the mount down on bed (as seen on picture).