A quick model I threw together so that I could make sure my iphone was actually centered to the QI so that it would charge correctly. I made it so the phone sits up at a 45 degree angle so that I could see it better from my pillow. I don't recall the QI charger brand...it was a gift. Also, I take my case off to charge (thanks pop-socket!) so the stand fits the bare phone. I have some updates I might make to it based on my usage. I may also make varients of it to fit a wider range of phone/case/qi sizes, but for now this works well for my own needs. I'm using crystal PLA, so the indicator lights on the QI charger actually glow through the plastic.
Prints in one piece sitting base down without supports.
Anyway, if this does you any good...enjoy!
makergeek crystal series PLA