Yet another Flying Extruder bracket.
This one is designed to fit a "Two Trees" titan extruder replica, obtained off of AliExpress. Existing extruder brackets didn't fit. The extruder is suspended using 3mm PVC tubing (sold as 'elastic twine' by garden centers over here), with 2.9 x 9.5 mm wood screws screwed into the ends of the tube. The holes in the base plate are designed to fit snugly around this, while still allowing easy installation and removal (so you don't need to install the tubes before mounting the extruder and stepper motor)
A hole in the side wall allows access to the idler tension adjustment screw.
Devil Design PETG
Print with supports, but block supports around the small holes in the NEMA-17 mounting bracket.