This is the release of the Eaglemoss 1/8 scaled Exhaust vents
These were created from an original Delorean 1/8 parts, And added more details and weld lines.
These parts are tricky to print, I have had good results with the fans pointed up, and you can add lots of support on the inside, as you won't see this when it is painted black.
The holes for the screw have been made mor sturdy, to prevent breaking when adding screws, you can use the same screws as the original parts.
I have resin printed the parts on my Epax 1, and the files fit the workspace, and as the Anycubic Photon, or most resin printers have the same platform size, it should be no problem printing both parts at once.
Printing time on my Epax was 10 Hours at 0.025 resolution, and they came out fantastic, you might even get away with 0.03, but I don’t think you should go higher than that, you might loose the fine details of the weld lines.
These vents are not mirror images of each other, as there is detail on top and sides the differ between the two.
If you are printing these for someone else, please keep the price low, this hobby is already pretty expensive, and denying someone accurate parts because of price, is not nice.
Adjusting the files, or cutting into sections, can be done using Meshmixer, a free mesh editing program,
And there are a lot of instructions videos available on Youtube.
And don’t forget to post your results and also have fun :)