E3d V6 Zesty Nimble Mount, with dual 5015 fans, adjustable surround part cooler, and BL Touch mount.
- No loss of x/y travel
- Z height gain > 15mm over original hot end mount
- Height adjustable surround cooler (remix of https://www.thingiverse.com/thing:2502178)
- Dual 5015 radial part cooling fans
- Adjustable BL Touch Mount
Requirements / BOM:
This thing is remixed from the following designs:
(Assembly Guide Below. PDF Version in files)
Two Trees Sapphire S (PETG/PLA) / Prusa Mk2s (ABS)
0.3 (0.15 for part cooler)
Generic ABS, PETG, PLA
Use ABS for the V6 Bracket, Clamp, and Part cooler.
Use PETG for Fan Ducts, Top Bracket
Use PLA or PETG for BL Touch Bracket & Fan Brace
Everything was printed with 3 perimeters
Ducts - Printed upside down & I enforced support on build plate only for first 12 layers for the internal fan rim
V6 Bracket - Supports on build plate only (optional)
Part Cooler - 0.15 layer height or better, plus supports to ensure air holes are correct
Nimble Bracket - Support on build plate only
This thing is designed with tight tolerances to ensure it fits within the frame constraints, sanding/filing of parts may be required to remove any elephants foot issues, or printing variances.
I found it useful to use a tiny dab of superglue on the hex nuts to prevent them from falling out of place during assembly, use a bolt to locate/seat them correctly before attempting assembly.
The BL Touch must be mounted with the cables facing the hot end, to ensure they do not clip the belts.
Note : The hot air vents for the V6 Fan may not be sufficient at higher temps. I have drilled a 10mm hole in the original steel rail mount to provide additional ventilation, this may not be required as I have not experience any issues in the duration I have been operating this design.
Quick Video : https://youtu.be/09-I7vaquRA