3d Solutech PLA
An 8mm Brim is recommended for adhesion purposes.
Hardware Required for Assembly
Screws: #10 x 3/4 in Pan Head Phillips Screws (x6)
M3 x 8mm Screws (x2)
Axle Adapters: REV High Strength HEX Adapter (x1)
1: Remove support material from the finished print.
2: Press a REV high strength hex adapter into the side of the plate with a round, filleted riser. The bolt holes on the adapter should line up with the large circular indents on the opposite side of the plate.
3: On the side of the plate with the circular indents (opposite to the side with the high strength hex adapter), screw two M3 x 8mm screws into the plastic/hex adapter to bolt the adapter in place.
4: Press the completed assembly into the side of a mecanum wheel with the hex adapter facing away from the wheel.
5: Using six #10 x 3/4 in Pan Head Phillips Screws, screw the assembly into the wheel.