Basic sleeve case for the Raspberry pi 3 b and b+.
This is a remix from https://www.thingiverse.com/thing:1015706.
It has been redesigned to fit my needs better, no headphone jack and no front cover for easy installation. It's a tight fit, but with some work it'll snap into place. Very difficult to get out, which was the intention. The SD card can be inserted into the case after the pi is installed but it is difficult to remove without needle nose pliers or tweezers.
FWIW I use 70mm/s print speed and the platform is at 60C with the extruder at 205C.