Replacement part for the nose gear of the Apprentice S15e.
I didn't want to buy the whole nose gear replacement kit, because i only needed the arm, so i designed one by myself.
Both parts can be glued together, but they don't have to if the tolerances are right. The two parts of my printed arm are holding together fine without any glue.
I printed it with a 0.25mm nozzle. The small lip on the top part might not be printable with a 0.4mm nozzle, but i don't think this makes any difference. Please tell me, if the tolerances are too tight for you.
I recommend printing it with 100% infill for maximum strength.