I modeled this small door (using Fusion360) to revamp an old dead tree stump in our yard. I'll be putting the door at the base of the stump so that the stump looks like a little hobbit house!
I printed this on a single extruder printer, but with color changes at strategic heights. See photos for a picture of what my slicer with the color changes looked like.
Printed at 100%, this thing is roughly 16 cm high, and 8 cm wide. I changed the infill orientation to 0 degrees so that the infill on the top would be vertical, making the wood panels look more like wood. I also highly recommend printing with
If anyone prints this, please share! I would LOVE to see what you guys might do with this.
P.S. The filaments I used in the pictures are the following:
- Brown → Polyalchemy Walnut FX PLA
- Black → Eryone PLA
- Granite/marble on the steps → can't remember!
Use a brim to avoid warping. I used 7mm.
When I printed without a brim I had a lot of warping and the print was not able to complete.