I'm too lazy to print cable drag/cable chain. Its too many version, and the other problem is, my printer quite fail each time I print cable chain. So i decide just to buy it.
size for my cable chain approx: W=25.5mm X H=13mm. (one side roll up)
In this design, i did not make a hole for screw. Instead, i just drill 2 holes each to holds the end of cable chain. By the ways, actually its fit tide with this cable chain size. Others, its easy to mount and apply. Only minor drill and small screw should be done.
Please refer to my picture for the screw position that i mean. (because i'm so poor in english)
There's only 3 file.
a. "x-axis end" has a bit larger acrylic clipper
b. "y-axis end" small acrylic clipper (got some small holes.)
c. "xy-axis statt" - This is for the start of cable drag (cable from board will go from here first) - Please mount it reverse as per sample images. You need to print this 2 unit for X-axis and Y-axis.
Print this with no support needed.