Pardini SP 22LR Magazine Modification
This modification will allow you to get 6 cartridges into the Pardini SP magazine.
In Skandinavia some shooting competitions requires a 6 cartridge magazine, this modification was made as an non destructive modification to the magazine.
Make sure that your printer is calibrated, and slow down the print speed (I used 30 mm/s)
Do not print in PLA the heat resistance is to low. Print parts in ABS.
It should print fine on Ender 3 without an enclosure. Use ABS juice and brim to avoid warping. Please orientate all parts as shown in the fourth picture.
After printing make sure to remove all the support, pay spesial attention to the bottom plate where the magazine body slides into the bottom plate. Do a test fit of all the parts before assembling. Trim the parts if required. Make sure to apply a small amount of gun oil the the bullet follower before assembly.
This modification is done on your own risk. I do not take any responsibility and I am not liable for any damage caused through use or installation of this modification.
The use and installation of this modification is done at your own risk.
Nozzel : 0.4mm Layer height: 0.2mm
Printed using brim
Wall thickness 1.2 mm
Print speed 30 mm/s
Designed with very tight fit, make sure printer is calibrated.