Replacement loop for the Garmin Vivoactive strap.
After the loop on my strap broke it was time to replace it with a more durable 3D printed version, and the color is a nice touch for personalization
The loop is a little less wide than the original, which means it needs a little stretching when slipping over the buckle but then it stays in place better than the original, and think it will prove much more durable!
Printed on Prusa MK3 with Ninjaflex, 100% concentric infill
The key settings are the right tension of the print head gear, the right temperature and most importantly LOW speed. I went to 25% from Prusa's standard, and it took 1 hour to print the loop, but the result is excellent. No stringing and very nice surface finish.
Print bed prepared with a very thin layer of glue stick