I found this Vape Protector on here, and I had some issues with it, and some additions a customer wanted for a job I was doing. I had to resize the model a bit, as it was below 25mm when printed in PETG, so it's been properly sized to be a little over 25mm. I also added two holes at the top which are for a lanyard or anything to hang it or clip it. That was a request from my customer I have added into the file.
I normally do five vertical shells for extra strength, but feel free to do as many as you think you'll need. Prints in about 3.6 hours with five shells
Back for the charger
Dropped off at the customer and on display
Magenta batch completed