v2.0 Corrects the doubled vectors, so you don't cut the same part twice. Screw holes are slightly bigger, so you don't have to drill them out, Connector holes are lower on the case, so you only need one nut under the PCB as a standoff. Last but not least, the living hinge on the STL top has wider slits so it's easier to print.
Not much else to say. It's a remix of a great design by McNugget. Can be laser cut or 3D printed, or both!
For 3D printing, I hame 1.2mm walls, no top or bottom infill, 22% grid fill. This makes it very airy when printed.
For laser cutting, just 3mm acrylic.
Screws are M3-12. You will need six (6).
Nut you will need ten (10) reserving four to use as standoffs under the PCB. The PI holes are just shy of 3mm, so you will need to open them up a bit.
0.00 mm Top and Bottom Layers for the see through grill