These longer 90 degree pigtails will make the routing from the back of the VTX into the mount way easier. I have a 3 inch currently and it is just too tight of a fit so i'm going to use either a 6 or 8 inch that I ordered. 4 inch may be enough as well but for sure 6 should be long enough.
6 inch - https://www.amazon.com/gp/product/B0765BSKCW/
8 inch - https://www.amazon.com/gp/product/B07658BN6J/
Fixed file orientation so they load how they should be printed.
Switched up the naming of the files.
TBSUnifyPro32HV_RX - Just the mount for VTX and RX
TBSUnifyPro32HV_RX_GPS-Small - Adds 18x18mm GPS Mount (BN-180 style)
TBSUnifyPro32HV_RX_GPS-Large - Adds 28x28mm GPS Mount (BN-880 style)
Here is a link to t he Antenna Tubes i'm using that fit nicely.
Added pictures of the V7 installed with the GPS in it.
Added V7 which adds an attached BN-880 GPS holder. I attached some new photos of it on my desk with the GPS in the mount. I don't recommend using this with a stubby antenna though. A standard or shorty should be fine to clear the GPS mount. Use V5 if you don't want the GPS mount.
My frame arrived today and everything fits together nicely. I posted a picture holding the top plate on with everything together. I don't forsee any further changes that are needed at this time.
Added V2 which changes the mount style to give an extra 4mm of clearance for the Unify. Also now has cut outs that should line up with the USB and button. The LEDs should be visible since the side rails are only half the height of the Unify.
The rounded slot can take a small zip tie to secure the Unify and/or the antenna mmcx pigtail. I plan to use a 90 degree pigtail and zip tie it down before it goes to the SMA mount hole.
Added V3 which should provide more clearance for the pigtail and adjusted the button slot to match the USB side.
V5 added and previous images and version removed. Access points are better lined up and other small adjustments. I just need to test the fitment on the frame now.
The existing design didn't allow for me to mount the new TBS Unify Pro32 HV. I changed the width of this to accommodate 25mm and hope the 37mm length of the Unify still has room when mounted in this.
I will post pictures after all the parts have arrived and I get it assembled.