MakerBot Print is our newest print-prepration software, which supports native CAD files and STL assemblies,
allows you to interact with all your printers via the Cloud, and many other exciting new features.
I did some improvement based on issue i faced during the assembly and tweaks to my liking
added cavity at the middle lower floor so i could hide my tiny D8 receiver and lipo beneath
i made it a snowcat with rear bed instead of rear cab
reduced the hexagon hole from 6mm to 5.7mm because it was rotating inside
added cover behind the dash
modified the sprocket to mount on servo horn
added a printable bearing in case you can't find one
The Track is the Lego 3873, total 60pcs.
You may notice in the pics where one has foam pads, another doesn't.
a. Original track without foam pads - super smooth
b. with foam pads added - it's a little bit more jumpy
*tips - apply foam pads on all the tracks, if you just apply half, it's a lot more jumpy
The "front cover" is to be placed behind the "dash" with a recess at the middle for your fpv camera wires to go through.
Install the idler sprocket with its nut first! then you may install your servos. *otherwise if you are too excited like me, you have to reinstall the servo
now install your servo and the servo sprocket
pull the wires to the top
now glue the lower body and upper body
install the remaining electronics which are quite self explanatory
Do update if there's any issue and share your makes!
Remember to come back and post what you've printed as Make.
It's good for the designer and the community (that means you)!
To post a Make, come back to this Thing and click Post a Make.
Or, you can use the Thingiverse Mobile app found on
and the Apple App Store.