A replacement for the air flow direction part attached next to the hotend. Due to the distance to the actual hotend, I recommend materials that can print at low temperatures, but require high temperatures after that to melt. Otherwise you will run into problems later on.
This part is designed to fit with the standard Anycubic hotend, which has the nozzle approximately 17.3mm from the metal block holding the hotend.
0.1 - 0.3mm Layer, 0.1 - 0.4mm Nozzle
Any ABS; PC; PLA; Nylon;
Better resolution is better for the screw holes, but you might run into problems with the print speed due to the extremely thin walls.