This is the Floss 3.0 Command Center. The perfect accessory for your long range Floss 3.0 where signal reception is a high priority. It includes a GoPro Hero 5/6/7 mount (Session mount will be added soon) that is fully adjustable between 10 - 40 degrees. There are markers in 5 degree increments so you can accurately and consistently adjust the angle for your needs. Props are NOT IN VIEW when shooting in the WIDE setting(as I do). If you use Superview, I believe you need to be at 15 degrees or more to keep the props out of view. It also includes a spot for your VTX, RX, GPS, SMA antenna, along with both horizontal and vertical Immortal-T options. You can fit both a horizontal and vertical Immortal-T antennas for diversity. The vertical antennas are positioned to allow good front/back visibility without being blocked by the GoPro. The back spine is also a great spot for an LED strip like the 8-LED WS2812 programmable RGB strips.
For best fit and function, the components I used and designed this for are the TBS Unify Pro V3 video transmitter, TBS Crossfire NanoRX receiver, and the HGLRC GPS. Other components may work but those are the components I have tested and they work very well.
Also included is a mount for your XT60 connector and a 1000mfd 50v Panasonic FM series capacitor on the rear.
You will need (2) M3x25mm bolts with flanged lock-nuts for the GoPro mount. I highly recommend using washers to mount the Command Center to the Floss top plate. There is also a hole in the bottom for a zip-tie to help secure the middle part of the mount. You will need to use zip-ties to secure the Immortal T antenna if you choose to use the vertical mounting option(s).
Here is the full list of components used to build my 7" long range setup:
7" Floss 3 w/ braces
BrainFPV Radix FC
Aikon AK32 35a ESC + 50v 1000mfd capacitor
WhoCares 2200mah 6s
Dal Cyclone 7056
Runcam Micro Eagle
Unify Pro V3 w/ Spedix Pagoda
Crossfire NanoRX w/ Immortal-T
Here's a video of it in action, 2 miles out.
UPDATE: 6/27/19 - Added Session Mount + modified printing instructions
The Command Center prints with NO supports on a well tuned printer. You will need to cut out the SMA mounting holes with an Xacto knife. For best results use 2mm thick bottom and top layers and a 1.5mm shell. Print at 0.25mm layer height.
The XT60 Capacitor mount prints with NO supports. Print at 100% infill with 0.3mm layer height.
The GoPro Hero mount REQUIRES full supports. Print at 20-100% infill with 0.3mm layer height.
The GoPro Session mount REQUIRES full supports. Print at 20-100% infill with 0.3mm later height. HIGHLY RECOMMEND PRINTING IN BLACK!!! If you print this mount in color and use ND filters you will see the TPU color bleeding through the edges of your video. If you want to print it multi-colored, make sure to print the first and last 10-15mm in black.
All models include an easy-to-remove brim.
All parts are designed to be printed in TPU. For best results, use Sainsmart TPU.