This type of enclosure is built around TTGO T5S board.
SoftRF & SkyView is an open project (GNU LGPL) for aircraft collision avoidance avionics.
SoftRF is compatible with four most common ISM band aircraft collision avoidance protocols:
- "Air V6" ;
- OGN tracker ;
- PilotAware ;
- FANET+ (Skytraxx).
NOTICE: This design is applicable for revision V1.9 of T5S. Other revisions may not match.
If you are unable to print the parts by yourself - you may consider to find an appropriate local 3D service provider and place an order with assistance of 3DHubs or Treatstock portals.
Use of heat-resistant filament (such as ABS) is recommended. Scale the model 0.3-0.5% up along XY axes in this case to compensate shrinkage of ABS while cooling down.
It is also recommended to use supports for Holder part.
Fasten the T5S board to the enclosure's main body with four 2.5x10 mm screws. Put face plate on top of the assembly.
Put 40 mm speaker inside the printed mount.
Fasten the mount to the enclosure's main body with four 2.5x8 mm screws.