Designed to fit an A6 bowden extruder with an upgraded motor (42x42x48mm). It includes a slot for securing a cable tie but I've found that the friction fit is sufficient.
- Use a 16mm flat wood bit to drill a hole.
- Drop in the insert.
- Seat the mount over the insert.
- Screw in place.
- Slide the bowden tube through the insert.
- Insert bowden tube into coupler.
- Seat motor in holder.
- 1 x M3x16mm hex screw
- 2 x M3x20mm hex screws
- 3 x M3 washers
- 2 x M4x20mm wood screws