this is another thing I haven't printed yet, this time, however, because I don't think my printer is going to be able to handle the intense incline. you might have to go into a slicer and move it around a little bit as I didn't think to position it to print well.
this was a very easy design in fusion 360. I just made a sketch around 65x30 for the base, extruded it 2mm made a sketch on the z-axis, made a diagonal line going around 110 degrees and I think 80 or so mm long (I'm doing this all by memory.) I then made the hole for the popsocket around 31 mm and 10 or so mm from the top. I measured my charger and input the dimensions then I added a 2.5mm fillet and extruded that. sorry if that wasn't the greatest instruction every, I am rushing and am lazy.