My mom went through her sewing kit and had a few hundred buttons so I designed this to hold them in her kit. It is printing now in Warhorse wood PLA. I will upload the lid after work and photos. The lid I want to see if I can knurl the out edge and may use a different color pla. and looks like I will be printing again somehow one of the o's go deleted. I will fix and re-upload after work.
I left it without the one O, the threads are real thick and need some work to get the lid on but it's done.
I am printing with brim and tape under the brim so the actual can part will be right one the glass. do 1-1.2mm walls/shells and bottoms/tops and 20% infill and it should be water tight, I don't think I would do that with wood pla though.