Based on the awesome switch dongle by Devezu (https://www.thingiverse.com/thing:3422014) which is also based on mwinzer's original one ( https://www.thingiverse.com/thing:2876621).
There are a few changes made to make printing and assembly easier, as well as making the finishing better.
The plastic rods that hold the board in place are now screwholes. They take M2 screws, this was made with the gray philips screws of the dock in mind.
The holes to screw the case halves together now also take M2 screws, I used the triwing screws that hold the board in the original dock. The black, long ones. The holes were also extended so they are on the same plane as the rest of the case. This makes printing without supports easier.
The holes for the ports were adjusted so they match the ports themselves better.
The slot where the led board would fit was too tight, so you had to fold and press the pins quite a lot to get them to go in. The slot now has space for the pins.
A bit of extra vertical space between the slots and pegs that join the halves so they connect easier without sanding.
- A version without the logo is included so it is easier to sand or post process the parts.
Other than that it is the same as the MK2.