Kudos to Wendigo013 for the original design!
This little piece of plastic will lock your FeiYutech Vimble 2 securely in place for transport without having to carry the nice but bulky case.
It's functionally identical to Wendigo's original design, just a bit optimized to suit my needs better.
- No supports needed
- Uses about 8g of filament
- No sharp edges
- Easy to install/remove
- Scale it up/down a bit to get the fit just right depending on printer calibration
- .2mm layer height is fine
As always the original design file (fusion360 + STEP) is included, so feel free to improve it (or learn from it)!