This is a custom hdd holder bay, which holds a hard disc with rubber cord.
It is intended to isolate the disc vibration from the case, in order to reduce overall noise from your pc.
I used it in a custom build case, however it should fit in the larger slots in most cases. Keep in mind that it might be a little fidgety to get the disc holder part to move freely, since space is limited.
You need to print:
2 x Side
1 x DiskTray
In addition to the printed parts you need approximately 2 meters of 2mm thick rubber cord.
- cut 4 strips of 2mm rubber cord with approximately 50 cm length each
- tie a knot into one end of each strip and
- weave them into the side panel and disc holder part.
I found it helpful to soak a little bit of CA-glue in the end of the cord, let it dry and then cut in the middle of the glue spot to have a clean tip to weave with.