This is a design to make your own DIY headset with just some simple earbuds! This method is much cheaper than buying an actual headset.
If your microphone is too quiet and you can't turn it up any louder, this print is for you. The earbud headset holds your microphone on your earbuds closer to your mouth so your device can hear you better.
This is a simple two-piece print that is easily assembled and ready to go right away. Just pop in your earbuds, and easily remove them when you are done.
The earpiece should be printed in flexible filament in order to allow fit for any size ear.
Any PLA and PLA flexible
100% (change for the earpiece to change flexibility)
Black and Green
Print the Earpiece in flexible filament and the Curved Mic in regular filament. If you don't have flexible filament, the Earpiece should print just fine in regular material.
Make sure to have supports for both the Earpiece and Curved Mic prints.
Attach and glue the pieces at the joint
Put the Earpiece joint in the Curved Mic joint and attach them. They might stay, but just to make sure I would superglue or hot-glue the pieces together, since flexible filament is, well, flexible and more squishy.
Then, simple feed your earbud cord through the device and make sure to have the microphone pointing up in the Curved Mic piece.