I went looking for a good x carriage for the Chimera+ and I couldn't find one so I made one. it will work for the cyclops+ as well.
note:THIS WILL ONLY WORK FOR THE NEW CHIMERA+ AND CYCLOPS+ if you have an older version, "pre +" this will not work
I've been loving my design the only downside seems to be accessing the tubes as my old chimera clone had different pneumatic fittings that protruded out of the holes I could easily remove the bowden tubes. with the official e3d chimera+ the fittings are inset and the whole chimera needs to be removed from the carriage to remove the tubes. not the end of the world but I may change it later.
I printed it in PETG as the temps can get high and deform the fan duct if printed in PLA.
meant for 45 mm linear rod spacing
amazon basic PETG
rotate the mount so that the BLtouch side is on the bed.
the fan duct should be printed so that the big whole is on the bed.