This is a remix of BadWolfProps' fantastic Functional Cryocan Replica Prop. All credit goes to him, as I did not design this prop, I merely remixed it to achieve specific results:
- The channel for the O-Ring on the base part wasn't wide enough to accomodate the specific type that I am using (I will add a part number here later).
- The actual screen-used prop had the 'CO2' canister part of the prop extend all the way, or at least much further down the prop, as in it's 'stored' state, no top seam is visible. I tried to reproduce this as best I could.
To print this prop properly you will need to download BadWolfProp's version 4 cryocan first, and replace three files with mine:
jp_canister_functional_v4_top_cylinder_lengthened (my modified version)
jp_canister_functional_v4_top_cylinder (badwolfprops original)
jp_canister_functional_v4_base_biggeroring (my modified version)
jp_canister_functional_v4_base (badwolfprops original)
jp_canister_functional_v4_1_tall_cylinder_shortened (my modified version)
jp_canister_functional_v4_1_tall_cylinder (badwolfprops original)
I will not repost the other files here, in an effort to make sure that any attention to this prop requires BadWolfProps' files, and thusly drives traffic back to his work.
In the event that BadWolfProps would like this removed, I will happily do so.
Modification: Altered the groove for the O-Ring (In blue, above pink, and fixed overlapping mesh by hole)
Detail of the depth added (contracted groove inward) ever so slightly to accommodate thicker O-Ring.
Before modification. O-Ring hangs over the edge of the printed base too far.