Please Keep in mind this model is being provided not for the profit of any stores or etsy use. I am providing this model for the community and it is intended to be free. Please do not sell this in Etsy shops or fairs or anything else. let's keep it good people
I got bored one day and decided to make a holder for my code Cylinders for my tie pilot troop case. Just something so they don't rattle around loose. I printed this without supports.
Super Glued the plate in place and used some velcro I had lying around to work as a retention strap across it all. I attached the Velcro strap using E6000 I had lying around. In the future, I may just use Elastic and a snap to close across the top.
This is only a draft, but it serves it's purpose. You can see the prototype in the pics included.
One thing I also tried was using clear "Plasti-Dip" to coat the inside of the tubes so they don't rattle. If you try this, use a heat gun on Very Low or No Heat setting to cure it. Otherwise you will need to wait days for it to cure on it's own. It is made to cure on metal quickly, not PLA.
I plan to attach it to the inside of my troop case with a bit of high strength Velcro to hold it in place.
I know it isn't the prettiest solution around, but it definitely gets the job done for me.
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/i9dIGOK24nc
Amazon Basics PLA
I actually colored the raised portions of the name plate with a gold sharpie. I know very technical. ;-) then hit the whole thing with clear coat before adding the Velcro.