Mount for a fan (40x40x10) and a heatsink (40x40x11) to be used in Nema17 stepper motors. Snaps well in place.
Used with the Z Stepper on an Ender 3 Printer.
Preferable to use thermal paste between heatsink and stepper in order to achieve better heat transfer.
Use high-temp plastics such as PETG or ABS. The part will be in direct contact with the stepper, so PLA will soften easily. I used ABS.
-M3x15mm Screws (x4)(Fan-Mount)
-M3x20mm Screw (x1)(Mount-Zed Bracket)
-M3x9mm Screws (x2)(Mount-Stepper)
-M4x8mm Screw (x1)(Mount-Carriage)
-M4 Locking Nut (x1)(Mount-Carriage)(comes with the printer)
Any question: feel free to comment down below.
-Use a slightly higher print temp than usual for stronger part. If the temp is too low it may break in assembly.