The only thing cooler than Pringles is the Pringles can. If you hate throwing away the cans as much as I do, than this print is for you.
By avoiding downward force on the top rim of the can we can prevent the cardboard from deforming, which often occurs when over-using the lid. That is why this design grabs the can from the side. In fact this clamp design will work on either end of the can!
The mounting rail for this project is easily extendable to accommodate as many can holding sections as needed. The rail also features counterbored holes for nails as well as depressions for Command stips to minimize the gap to the wall.
You can store anything in these Pringles cans. Even more Pringles!
The Grab and Go size is shown above, but you can easily swap these for regular or Mega Stack cans. (I honestly learned all of the sizes while doing this project)
There are a lot of directions to take this project and I hope to see people add to this!