Brighten up your day with this E27 Banana peel lamp!
It took me a long time to make this model printable. I've tried various slicers and supports but most didn't work. This is why I added the fixed walls to the model to support the overhangs. With the walls the model prints without any additional support and results in the cleanest overhangs. After printing the walls can be cut off and with some sanding, what's left over, is barely noticeable.
I added three models of the banana peel, one without the walls (if you find a way to print it with support I'd love to hear what support you used), one with narrow walls (for 0.4 nozzle) and one with wider walls (for 0.6 nozzle).
The hole inside the banana peel fits a basic E27 fitting, if you butcher it a little. Just cut some of the plastic at the end on one sit and it will fit perfectly.
Good luck printing and please upload your result :)
And check out my E14 banana lamp!