Self watering pot for vase mode
This is project of self-watering flower pot printable in vase mode (single outline or spiralize).
To print this, you are going to need wide nozzle, I used 0.8mm, which is sufficient. Wider nozzle will make the pot more sturdy, with this one it holds just fine. If you need flower pot for outdoor use, I strongly recommend to print this project with UV resistant filament like ASA.
Print both parts. Original size is 170mm high and 170mm wide when assembled (just enough for your balcony tomato).
Also check this Extendable funnel for vase mode if you are lazy gardener like me!
If you like this project, follow me on instagram!
Have fun gardening!
Devils Design ASA
any color you like
When you finish the print make sure that the outer part is water tight. If not, use any water / soil friendly way to clog any holes.